User's Manual
Table Of Contents
- Omni 5xxx and Vx5xx/Vx610 Installation Guide
- Contents
- Preface
- Terminal Overview
- Terminal Setup
- Selecting Terminal Location
- Unpacking the Shipping Carton
- Examining Terminal Features
- Establishing Telephone Line Connections
- Installing the Paper Roll in the Printer
- Installing/ Replacing MSAM Cards
- Connecting Optional Device(s)
- Connecting the Terminal Power Pack
- Vx610 Battery Behavior (No Power Cord)
- Installing the Privacy Shield
- Installing the Vx610 Smart Battery
- Using the Vx610 Spare Battery Charger
- Using the Vx610 Power Cradle
- Installing/ Replacing the SIM Card (GSM/GPRS Models)
- Connecting the Vx610 External Antenna
- Conducting Wireless Transactions
- Using the Smart Card Reader
- Using the Magnetic Card Reader
- Specifications
- Maintenance
- VeriFone Service and Support
- Troubleshooting Guidelines
- Blank Display
- Terminal Does Not Dial Out
- Printer Paper Jam
- Keypad Does Not Respond
- Peripheral Device Does Not Work
- Transactions Fail To Process
- Printer Does Not Print
- Terminal Display Does not Show Correct/ Readable Information
- Vx610 Terminal Does Not Start
- Vx610 Smart Battery Will Not Charge
- Printer Does Not Print
- Index
- Contact VeriFone
TERMINAL SETUP
Connecting Optional Device(s)
28 OMNI 5XXX AND V
X
5XX/V
X
610 INSTALLATION GUIDE
V
E
R
I
F
O
N
E
C
O
N
F
I
D
E
N
T
IA
L
T
E
M
P
L
A
T
E
R
E
V
E
V
x
610 Optional
Device Connections
The side port of the V
x
610 terminal can operate either as a PINpad port or an RS-
232 port, depending on the power source available.
Connecting the PINpad or Smart Card Reader to the V
x
610
Use the following procedure to connect a PINpad or smart card reader.
1 Insert the RJ45-type connector on the end of the PINpad or smart card reader
into the port on back of the peripheral device.
To install a PINpad 101, PINpad 201, or PINpad 1000, position and insert the
grommet to secure the cable connection.
If a cable is not already connected to the smart card reader or PINpad, insert
the small modular plug on one end of the interface cable into the optional
device’s modular jack.
2 Insert the larger RJ45-type connector on the other end of the PINpad cable
into the PINpad serial port on the side of the terminal. Figure 20 provides an
example of a smart card reader and PINpad connection to the PINpad serial
port.
Figure 20 V
x
610 Example PINpad Serial Port Connections
NOTE
When the V
x
610 terminal is powered via the corded power supply, the terminal
provides 400 mA at 9V DC to the side port. This power will drive most VeriFone
accessories. Contact your local VeriFone representative for more information.