User's Manual
Table Of Contents
- Omni 5xxx and Vx5xx/Vx610 Installation Guide
- Contents
- Preface
- Terminal Overview
- Terminal Setup
- Selecting Terminal Location
- Unpacking the Shipping Carton
- Examining Terminal Features
- Establishing Telephone Line Connections
- Installing the Paper Roll in the Printer
- Installing/ Replacing MSAM Cards
- Connecting Optional Device(s)
- Connecting the Terminal Power Pack
- Vx610 Battery Behavior (No Power Cord)
- Installing the Privacy Shield
- Installing the Vx610 Smart Battery
- Using the Vx610 Spare Battery Charger
- Using the Vx610 Power Cradle
- Installing/ Replacing the SIM Card (GSM/GPRS Models)
- Connecting the Vx610 External Antenna
- Conducting Wireless Transactions
- Using the Smart Card Reader
- Using the Magnetic Card Reader
- Specifications
- Maintenance
- VeriFone Service and Support
- Troubleshooting Guidelines
- Blank Display
- Terminal Does Not Dial Out
- Printer Paper Jam
- Keypad Does Not Respond
- Peripheral Device Does Not Work
- Transactions Fail To Process
- Printer Does Not Print
- Terminal Display Does not Show Correct/ Readable Information
- Vx610 Terminal Does Not Start
- Vx610 Smart Battery Will Not Charge
- Printer Does Not Print
- Index
- Contact VeriFone
TERMINAL SETUP
Connecting the V
x
610 External Antenna
42 OMNI 5XXX AND V
X
5XX/V
X
610 INSTALLATION GUIDE
V
E
R
I
F
O
N
E
C
O
N
F
I
D
E
N
T
IA
L
T
E
M
P
L
A
T
E
R
E
V
E
Connecting the
V
x
610 External
Antenna
VeriFone provides an external wireless antenna for some V
x
610 terminals. This
connection allows communication with your service provider to upload transaction
data from the terminal and download system upgrades to the terminal. Radio
service is activated by your service provider.
Installation
This section only discusses V
x
610 terminals with external antenna. If the V
x
610
arrives from manufacture with the antenna unattached, use the following
procedure to install the antenna:
1 Locate the antenna port on the back side of the V
x
610 terminal.
2 Align the connector on the end of the antenna with the connector on the end of
the terminal.
3 Push gently on the center of the base of the antenna until it slides into
position..
Figure 44 Align Antenna with Antenna Port
NOTE
Some V
x
610 terminals have an internal antenna and this section can be ignored.
Use only the antenna designed for your unit. Failure to use the proper antenna
results in the inability to establish a wireless connection.
CAUTION
Never hold the unit by the antenna; doing so may break the connection and void
your warranty.