User's Manual
Table Of Contents
- Omni 5xxx and Vx5xx/Vx610 Installation Guide
- Contents
- Preface
- Terminal Overview
- Terminal Setup
- Selecting Terminal Location
- Unpacking the Shipping Carton
- Examining Terminal Features
- Establishing Telephone Line Connections
- Installing the Paper Roll in the Printer
- Installing/ Replacing MSAM Cards
- Connecting Optional Device(s)
- Connecting the Terminal Power Pack
- Vx610 Battery Behavior (No Power Cord)
- Installing the Privacy Shield
- Installing the Vx610 Smart Battery
- Using the Vx610 Spare Battery Charger
- Using the Vx610 Power Cradle
- Installing/ Replacing the SIM Card (GSM/GPRS Models)
- Connecting the Vx610 External Antenna
- Conducting Wireless Transactions
- Using the Smart Card Reader
- Using the Magnetic Card Reader
- Specifications
- Maintenance
- VeriFone Service and Support
- Troubleshooting Guidelines
- Blank Display
- Terminal Does Not Dial Out
- Printer Paper Jam
- Keypad Does Not Respond
- Peripheral Device Does Not Work
- Transactions Fail To Process
- Printer Does Not Print
- Terminal Display Does not Show Correct/ Readable Information
- Vx610 Terminal Does Not Start
- Vx610 Smart Battery Will Not Charge
- Printer Does Not Print
- Index
- Contact VeriFone
TERMINAL SETUP
Connecting the V
x
610 External Antenna
OMNI 5XXX AND V
X
5XX/V
X
610 INSTALLATION GUIDE 43
V
E
R
I
F
O
N
E
C
O
N
F
I
D
E
N
T
IA
L
T
E
M
P
L
A
T
E
R
E
V
E
4 Screw the barrel nut finger tight to retain the antenna.
Figure 45 Tighten Antenna Barrel nut
Orientation
To establish good wireless communication (uplink), vertically align the antenna
with respect to ground and sky. For example, if standing and holding the terminal
horizontally, position the antenna approximately at a 90° angle to the unit (that is,
pointing up from the ground). This should point the antenna directly at the sky.
If the unit is on a flat surface (for example, a table top) position the antenna so that
it points directly at the sky.
Replacing the
Antenna
If your V
x
610 terminal has difficulties completing wireless transactions, you may
have to replace the antenna. Use the following procedure to replace the antenna:
1 Remove the existing antenna from the V
x
610 terminal:
a Unscrew the barrel nut to loosen the antenna.
b Pull gently on the center of the base of the antenna until it slides out of
position.
2 Align the connector on the end of the new antenna with the connector on the
end of the terminal.
3 Push gently on the center of the base of the antenna until it slides into
position.
4 Screw the barrel nut finger tight to retain the antenna.
NOTE
If an application (for example, SoftPay) is installed in your V
x
610 unit, a signal
strength indicator may appear on the display.