User's Manual
Table Of Contents
- VX 520-G Installation Guide
- Contents
- Preface
- Terminal Overview
- Terminal Setup
- Selecting Terminal Location
- Unpacking the Shipping Carton
- Examining Terminal Features
- Establishing Communication
- Loading a Paper Roll in the Printer
- Installing/ Replacing MSAM Cards
- Installing or Replacing SIM Card
- Connecting Optional Devices
- Charging the Smart Battery
- Connecting the Terminal Power Pack
- Privacy Shield (Optional)
- Using the CTLS Reader
- Using the Smart Card Reader
- Using the Magnetic Card Reader
- Specifications
- Maintenance
- Troubleshooting Guidelines
- VeriFone Service and Support
- Index
- Contact VeriFone
VERIFONE CONFIDENTIAL
DRAFT
TERMINAL SETUP
Installing/Replacing MSAM Cards
22 VX 520 GPRS CTLS INSTALLATION GUIDE
Installing/
Replacing MSAM
Cards
When you first receive your VX 520 GPRS CTLS terminal, you may need to install
one or more MSAM cards or you may need to replace old cards.
To install or replace
MSAMs
1 Remove the power cord from the power outlet.
2 Place the terminal upside down on a soft, clean surface to protect the display
from scratches.
3 Press the unlocking button and then lift the rear cover to access the MSAM
cardholder panel.
Figure 11 Opening VX 520 GPRS CTLS Rear Cover
4 Hold the MSAM cardholder panel, grasp firmly and pull upward to expose the
MSAM slots.
Figure 12 Removing VX 520 GPRS CTLS MSAM Cover
5 Remove any previously installed MSAM card by sliding the card from the
MSAM cardholder.
CAUTION
Observe standard precautions when handling electrostatically sensitive devices.
Electrostatic discharges can damage this equipment. VeriFone recommends
using a grounded anti-static wrist strap.
23
23