User's Manual
Table Of Contents
- VX 520-G Installation Guide
- Contents
- Preface
- Terminal Overview
- Terminal Setup
- Selecting Terminal Location
- Unpacking the Shipping Carton
- Examining Terminal Features
- Establishing Communication
- Loading a Paper Roll in the Printer
- Installing/ Replacing MSAM Cards
- Installing or Replacing SIM Card
- Connecting Optional Devices
- Charging the Smart Battery
- Connecting the Terminal Power Pack
- Privacy Shield (Optional)
- Using the CTLS Reader
- Using the Smart Card Reader
- Using the Magnetic Card Reader
- Specifications
- Maintenance
- Troubleshooting Guidelines
- VeriFone Service and Support
- Index
- Contact VeriFone
VERIFONE CONFIDENTIAL
DRAFT
TERMINAL SETUP
Installing or Replacing SIM Card
VX 520 GPRS CTLS I
NSTALLATION GUIDE 23
6 Install an MSAM card by carefully sliding it into the slot until it is fully inserted.
Figure 13 Installing an MSAM Card in a VX 520 GPRS CTLS Terminal
7 Close the MSAM cardholder panel, and then replace the terminal rear cover.
Installing or
Replacing SIM
Card
The VX 520 GPRS terminal supports the installation of a SIM (Subscriber Identity
Module) card. Use the following procedure to replace or install a SIM card.
1 Place the terminal upside down on a soft, clean surface to protect the display
from scratches.
2 Remove the battery.
Figure 14 Removing the Smart Battery
3 After removing the battery, you will see the SIM compartment.
23
3!-
3!-
3!-
NOTE
Before inserting the MSAM card, position it as shown in Figure 13, with the card’s
gold contacts facing down. The cardholder connector base has an image
resembling the notched corner of an MSAM card to ensure the card is positioned
correctly.