User's Manual

VERIFONE CONFIDENTIAL
DRAFT
TERMINAL SETUP
Connecting Optional Devices
24 VX 520 GPRS CTLS INSTALLATION GUIDE
4 Insert the SIM into the cardholder.
Figure 15 Inserting SIM Card
5 Install the battery.
Connecting
Optional
Devices
The VX 520 GPRS CTLS terminal supports some peripheral devices designed for
use with electronic point-of-sale terminals.
Different terminals support different devices, so for more information about
optional devices, please contact your VeriFone distributor.
Optional Device
Connections
The VX 520 GPRS CTLS terminal has a port that can operate either as a PIN pad
port or an RS-232 port, depending on the power source available.
Connecting a
PIN Pad to the
VX 520 GPRS CTLS
Use the following procedures to connect a PIN pad or smart card reader.
1 Remove the VX 520 GPRS CTLS terminal rear cover.
2 Insert the RJ-45-type connector of the PIN pad or smart card reader into the
port of the peripheral device.
To install a PINpad 101, PINpad 201, or PINpad 1000, position and insert the
grommet to secure the cable connection.
3)- 3)-
3)-
A B C
23
CAUTION
Before connecting any peripheral device, remove the power cord from the
terminal and ensure that the green indicator LED is not lit. Reconnect the power
cord only after you are finished connecting the peripheral device(s). For complete
information about peripheral installation and use, refer to the user documentation
supplied with those devices.
NOTE
When the VX 520 GPRS CTLS terminal is powered via the corded power supply,
the terminal provides 4.0 A at 9.3V DC. This power will drive most VeriFone
accessories. Contact your local VeriFone representative for more information.