User's Manual
Table Of Contents
- VX 520-G Installation Guide
- Contents
- Preface
- Terminal Overview
- Terminal Setup
- Selecting Terminal Location
- Unpacking the Shipping Carton
- Examining Terminal Features
- Establishing Communication
- Loading a Paper Roll in the Printer
- Installing/ Replacing MSAM Cards
- Installing or Replacing SIM Card
- Connecting Optional Devices
- Charging the Smart Battery
- Connecting the Terminal Power Pack
- Privacy Shield (Optional)
- Using the CTLS Reader
- Using the Smart Card Reader
- Using the Magnetic Card Reader
- Specifications
- Maintenance
- Troubleshooting Guidelines
- VeriFone Service and Support
- Index
- Contact VeriFone
VERIFONE CONFIDENTIAL
DRAFT
TERMINAL SETUP
Connecting the Terminal Power Pack
28 VX 520 GPRS CTLS INSTALLATION GUIDE
2 Insert the round barrel connector (see Figure 20) into the power port.
Figure 20 VX 520 GPRS CTLS Power Connection
3 Rotate the power plug counter-clockwise and flush against the side panel to
lock the plug in place.
4 Route the cable in the direction of the arrow above the power port and sling
the cable over the underside of the thermal paper container.
5 Close the terminal rear cover.
6 Insert the AC power cord into the power pack.
7 Plug the AC power cord into a wall outlet or powered surge protector.
When the terminal has power, the terminal lights are activated and the LED
indicator remains lit.
If an application is loaded in the terminal, it starts after the initial VeriFone
copyright screen and usually displays a unique copyright screen. If no application
is loaded in the terminal,
DOWNLOAD NEEDED appears on screen after the initial
VeriFone copyright screen.
23
B
A
C
D
WARNING
Do not plug the power pack into an outdoor outlet or operate the terminal
outdoors.
Disconnecting the power during a transaction may cause transaction data files
not yet stored in terminal memory to be lost.
To protect against possible damage caused by lightning strikes and electrical
surges, consider installing a power surge protector.
NOTE
VeriFone recommends connecting wall power in the following order:
1 Connect the terminal to the power supply.
2 Connect the power supply to the power cord (if applicable).
3 Connect the power cord to the wall outlet.