User's Manual
Table Of Contents
- VX 520 Color D/E CTLS
- Audience
- Organization
- Related Documentation
- Conventions and Acronyms
- Terminal Overview
- Terminal Setup
- Selecting Terminal Location
- Unpacking the Shipping Carton
- Examining Terminal Features
- Establishing Telephone Line Connections
- Installing a Paper Roll in the Printer
- Installing/ Replacing MSAM Cards
- Connecting Optional Devices
- Connecting the Terminal Power Pack
- Privacy Shield (Optional)
- Using the CTLS Reader
- Using the Smart Card Reader
- Using the Magnetic Card Reader
- Specifications
- Maintenance
- Troubleshooting Guidelines
- VeriFone Service and Support
TERMINAL SETUP
Connecting Optional Devices
24 VX 520 COLOR D/E CTLS INSTALLATION GUIDE
V
E
R
I
F
O
N
E
C
O
N
F
I
DE
N
T
I
A
L
TE
M
P
L
ATE
R
EV
F
Connecting the
PIN Pad or Smart
Card Reader
to the
VX 520 Color D/E
CTLS
Use the following procedures to connect a PIN pad or smart card reader.
1 Remove the VX 520 Color D/E CTLS
terminal rear cover.
2 Insert the RJ-45-type connector of the PIN pad or smart card reader into the
port of the peripheral device.
To install a PINpad 101, PINpad 201, or PINpad 1000, position and insert the
grommet to secure the cable connection.
If a cable is not already connected to the smart card reader or PIN pad, insert
the small modular plug on one end of the interface cable into the optional
device’s modular jack.
3 Insert the larger RJ-45-type connector on the other end of the PIN pad cable
into the PIN pad serial port on the terminal.
Figure 13 provides an example of
a smart card reader and PIN pad connection to the PIN pad serial port.
Figure 13 VX 520 Color D/E CTLS Sample PIN Pad Connection
NOTE
When the VX 520 Color D/E CTLS terminal is powered via the corded power
supply, the terminal provides 8V DC, 2.25A or 9.3V DC, 4.0A. This power will
drive most VeriFone accessories. Contact your local VeriFone representative for
more information.