User's Manual

DEVICE SETUP
Installing/Replacing MSAM Cards
VX 600 FOR THE IPHONE 3G/3GS INSTALLATION GUIDE 17
V
E
R
I
F
O
N
E
C
O
N
F
I
D
E
N
T
IA
L
R
E
V
I
S
I
O
N
A
.
5
Installing/
Replacing MSAM
Cards
When you first receive your VX 600, you may need to install an MSAM card or you
may need to replace old cards.
To Install/Replace
MSAM
1 Unplug any cables or chargers from the VX 600. Using your finger, push the
MSAM compartment door, located on the left side of the front panel, to eject
the MSAM tray. A small hole can be found under the center of the MSAM door.
If needed, use a paper clip to pull the door out.
2 Place the MSAM card on top of the tray with the gold contacts facing down.
3 Align the MSAM tray properly into the compartment and gently push the tray
until it locks in place.
Figure 6 Inserting an MSAM Card
Manual Startup
and Shutdown
To manually startup and shutdown the VX 600, hold down on the power button,
depicted in Figure 2.
Connecting the
VX 600 to a
Power Source
Plug the wall-mount charger to an external power source and connect it to the VX
600 to charge the device.
CAUTION
Observe standard precautions when handling electrostatically sensitive devices.
Electrostatic discharges can damage this equipment. VeriFone recommends
using a grounded anti-static wrist strap.
NOTE
Not all applications require the use of an MSAM card.
NOTE
Make sure that the MSAM card sits firmly on the tray. The MSAM compartment will
not close properly if the MSAM card is installed incorrectly.


$ % & '