User's Manual

DEVICE SETUP
Installing or Replacing MSAM Cards
14 VX 600 BLUETOOTH AGNOSTIC INSTALLATION GUIDE
Installing or
Replacing MSAM
Cards
You may need to install one or more multiple security access module (MSAM)
cards or replace the old cards.
To install or replace
MSAM cards
1 Place the VX 600 Bluetooth Agnostic face down on a soft, clean surface to
protect the lens from scratches.
2 Loosen the screw from the compartment door.
3 Slide out the compartment door to access the MSAM cardholders.
Figure 4 Removing screw and opening compartment door
4 Slide the latch to the right to unlock the slot. Lift the cardholder and install the
MSAM card by aligning the card and sliding it into the slots. When the card is
fully inserted, swing the cardholder closed and then slide the latch to the left.
Figure 5 MSAM insertion
CAUTION
Observe standard precautions in handling electrostatically sensitive devices.
Electrostatic discharges can damage the equipment. VeriFone recommends
using a grounded anti-static wrist strap.
NOTE
Before inserting the MSAM card, position it as shown in Figure 5, with the card’s
gold contacts facing away from you, toward the unit. The cardholder slot in the
VX 600 Bluetooth Agnostic has a set of contacts. The MSAM card has a notch on
one corner to ensure that it fits into the connector base in only one way.