User's Manual
Table Of Contents
- Vx670
- Contents
- Preface
- Terminal Overview
- Terminal Setup
- Selecting Terminal Location
- Unpacking the Shipping Carton
- Examining Terminal Features
- Examining Connection Ports
- Establishing Telephone Line Connections
- Vx670 Bluetooth® Support
- Installing the Paper Roll
- Installing/ Replacing MSAM Cards
- Installing/ Replacing SIM Card (GSM/GPRS Models Only)
- Using the Smart Battery
- Battery Behavior (No Power Cord)
- Installing the Smart Battery
- Connecting the Terminal Power Pack
- Charging the Smart Battery
- Using the Base Station
- Placing the Terminal Onto the Base Station
- Attaching the USB Dongles to the Base Station
- Charging the Spare Battery on the Base Station
- Conducting Wireless Transactions
- Conducting Smart Card Transactions
- Conducting Bluetooth® Transactions
- Using the Magnetic Card Reader
- Specifications
- Maintenance
- VeriFone Service and Support
- Troubleshooting Guidelines
- Terminal Does Not Start
- Terminal Display Does not Show Correct/ Readable Info
- Terminal is Unable to Go Online and Displays Connection Failure (for Bluetooth® variant)
- Smart Battery Will Not Charge
- Spare Battery in Base Station Will Not Charge
- Blank Display
- Terminal Does Not Dial Out
- Printer Does Not Print
- Printer Paper Jam
- Keypad Does Not Respond
- Transactions Fail To Process
- Index
- Contact VeriFone
TERMINAL SETUP
Installing/Replacing MSAM Cards
V
X
670 INSTALLATION GUIDE 31
3 Remove the battery.
Figure 18 Removing the Smart Battery
4 After removing the battery, the MSAM compartments are exposed.
5 Remove any previously installed MSAM card by sliding the card from the
MSAM cardholder.
6 Install an MSAM card by aligning the card and carefully sliding it within the
guides on the cover until it is fully inserted (see Figure 19). The MSAM card
holders are labeled MSAM1, MSAM2, and MSAM3.
Figure 19 Installing MSAM Card
7 Install the battery (see Figure 22).
NOTE
Before inserting the MSAM card, position it as shown in Figure 19, with the card’s
gold contacts facing the smart card reader end of the terminal. The cardholder
connector base has a set of contacts and a notch on one corner to ensure the
MSAM card is positioned correctly. The MSAM card has a notch on one corner to
ensure that it fits into the connector base in only one way. The MSAM
compartment door will not close properly if the MSAM cards are installed
incorrectly.