User's Manual

Table Of Contents
TERMINAL SETUP
Installing/Replacing SIM Card (GSM/GPRS Models Only)
32 V
X
670 INSTALLATION GUIDE
Installing/
Replacing SIM
Card
(GSM/GPRS
Models Only)
The V
x
670 terminal supports the installation of a SIM (Subscriber Identity Module)
card. Use the following procedure to replace or install a SIM card.
1 Place the terminal upside down on a soft, clean surface to protect the lens
from scratches.
2 Remove the battery.
Figure 20 Removing the Smart Battery
3 After removing the battery, the SIM compartment is exposed. The SIM card
holder is labeled RADIO SIM.
4 Insert the SIM into the cardholder.
Figure 21 Inserting SIM Card
5 Install the battery (see Figure 22).
NOTE
There is only one SIM slot, but there are multiple SAM slots. Make sure you insert
the SIM card into the SIM slot, as shown in Figure 21.