Installation Guide
Table Of Contents
- Vx670
- Contents
- Preface
- Terminal Overview
- Terminal Setup
- Selecting Terminal Location
- Unpacking the Shipping Carton
- Examining Terminal Features
- Examining the Handy-Link Connector
- Establishing Telephone Line Connections
- Installing the Paper Roll
- Installing/ Replacing MSAM Cards
- Installing/ Replacing SIM Card (GSM/GPRS Models)
- Connecting the Terminal Power Pack
- Using the Smart Battery
- Vx670 Battery Behavior (No Power Cord)
- Installing the Smart Battery
- Charging the Smart Battery
- Using the Vx670 Base Station
- Placing the Vx670 Terminal Onto the Base Station
- Attaching the USB Dongles to the Base Station
- Charging the Spare Battery on the Base Station
- Conducting Wireless Transactions
- Conducting Smart Card Transactions
- Using the Magnetic Card Reader
- Specifications
- Maintenance
- VeriFone Service and Support
- Troubleshooting Guidelines
- Terminal Does Not Start
- Terminal Display Does not Show Correct/Readable Info
- Smart Battery Will Not Charge
- Spare Battery in Base Station Will Not Charge
- Blank Display
- Terminal Does Not Dial Out
- Printer Does Not Print
- Printer Paper Jam
- Peripheral Device Does Not Work
- Keypad Does Not Respond
- Transactions Fail To Process
- Index
- Contact VeriFone
TERMINAL SETUP
V
x
670 Battery Behavior (No Power Cord)
V
X
670 INSTALLATION GUIDE 27
Standard Battery Pack
The standard battery has a capacity of 1250mAh. It is suited for WiFi and pay-at-
table applications where frequent charging is required.
High-Capacity Battery Pack
The high-capacity battery pack is larger than the standard battery pack and is
more suitable for GPRS/CDMA applications.
Smart Battery
Features
The following are features of the smart battery:
• Two Li-ion cells
• A fuel gauge module that
• monitors state of charge (voltage and percentage of capacity),
• communicates with the terminal (charge parameters and status),
• determines full charge capacity (on charge cycle and uninterrupted
discharge cycle), and
• automatically shuts down when cell voltage is extremely low.
• A safety circuit that
• prevents cell damage from overcharge, over-discharge, or overheating,
and
• activates when the battery is left in an unused terminal for extended
periods.
V
x
670 Battery
Behavior (No
Power Cord)
When you have finished connecting optional peripheral(s), you are ready to power
the V
x
670 terminal from the attached battery.
Manual Startup
Hold the green key down through a series of short beeps until the terminal
displays the startup screen.
NOTE
Conserve battery power by turning the V
x
670 terminal off when not in use. If the
terminal is not to be used for several days, remove the battery from the terminal
as it continues to discharge even when the terminal is turned off.
NOTE
If you connect the V
x
670 to a non-battery power source, the terminal shifts to
corded power mode and starts up automatically, regardless of the battery charge
state.