User's Manual

Table Of Contents
TERMINAL SETUP
Installing and Replacing SD Card
VX 675 I
NSTALLATION GUIDE 21
Dual SIM
VX 675 3G supports dual SIM and SIM detect behavior for SIM 2. SIM 1 is the
primary default SIM and SIM 2 acts as backup SIM.
Figure 10 VX 675 3G SIM Installation
Installing and
Replacing SD
Card
Vx675 3G and WiFi-BT support an optional SD flash memory.
Figure 11 SD Card Installation/Replacement on VX 675 3G/VX 675 WiFi-
BT
To install or replace
SD card
1 Turn off the terminal.
2 Gently pull the rubber covering of the SD card slot located near the smart card
reader and slide sideways to expose the card slot.
3 Insert the card into the slot.
4 Return the cover of the card slot.
Using the
Battery
The VX 675 terminal uses a single cell Li-ion battery (see Accessories and
Documentation for ordering information). The internal logic of the battery prevents
both overcharging and undercharging (a fault condition in which the battery level
goes well below the minimum acceptable charge and the battery becomes
unusable).
C
A
SAM1 - LOWER
SAM2 - UPPER
SIM 1
SIM 2
D
B
SAM1 - LOWER
SAM2 - UPPER
SIM 1
SIM 2
A
B
B
NOTE
The VX 675 terminal will only operate when the battery is installed.