User's Manual
Table Of Contents
- VX 675
- Contents
- Preface
- Terminal Overview
- Terminal Setup
- Selecting Terminal Location
- Unpacking the Shipping Carton
- Examining Terminal Features
- Examining Connection Port
- 3G Support
- WiFi Bluetooth Support
- Installing the Paper Roll
- Installing the SIM Card
- Installing and Replacing SD Card
- Using the Battery
- Battery Behavior (No Power Pack)
- Connecting the Terminal Power Pack
- Charging the Battery
- VX 675 Base Stations
- Powering Up the Base
- Docking the Terminal on the Base
- Undocking the Terminal from the Base
- Connecting to USB Host
- Conducting a Bluetooth Transaction
- Conducting Wireless Transactions
- Conducting Smart Card Transactions
- Using the Magnetic Card Reader
- ECR (Fiscal Module) Support
- Specifications
- Maintenance
- VeriFone Service and Support
- Troubleshooting Guidelines
- Contact VeriFone
TERMINAL SETUP
Battery Behavior (No Power Pack)
22 VX 675 INSTALLATION GUIDE
Battery Features
The following are features of the battery:
• Single Li-ion cell.
• A safety circuit that:
• Prevents cell damage from overcharge, over-discharge, or overheating.
• Activates when the battery is left in an unused terminal for extended
periods.
Conserve battery power by turning the VX 675 terminal off when not in use. Keep
the Li-ion battery inserted in the terminal and power up the terminal periodically to
check the battery charge. Do not let the battery charge fall below 10% for
extended periods of time as this may permanently diminish the battery capacity.
Recharge the battery by attaching the micro-USB end of the power pack to the
terminal and plugging the other end of the power pack into a wall outlet.
Battery Behavior
(No Power Pack)
The terminal shifts to power pack mode and starts up automatically when the
VX 675 is connected to a non-battery power source, regardless of the battery
charge state.
Manual Startup
Hold the green key down for about 4 seconds until the terminal displays the
startup screen.
The terminal lights up once the power is on.
NOTE
VX 675 battery pack is not customer changeable and therefore should not be
disconnected and removed.
Li-ion batteries are not affected by shallow charging. When the terminal has no
external power source or battery, the coin cell battery provides power to the
security circuit.
Disconnecting and removing the battery, as well as unplugging the terminal
power pack, reduce the life of the coin cell battery, which does not recharge and
must be replaced if drained.
NOTE
The 4-second power-up delay prevents terminal startup if the green key is
accidentally held down. The time required to hold the green key down to power up
the terminal is configurable (for more information, see the VX 675 Reference
Guide – VPN
DOC265-004-EN-A).
NOTE
The VeriFone copyright screen starts and displays a unique copyright screen
once the terminal loads an application. However,
DOWNLOAD NEEDED appears on
screen after the initial VeriFone copyright screen if there is no available
application in the terminal.