User's Manual
Table Of Contents
- VX 675
- Contents
- Preface
- Terminal Overview
- Terminal Setup
- Selecting Terminal Location
- Unpacking the Shipping Carton
- Examining Terminal Features
- Examining Connection Port
- 3G Support
- WiFi Bluetooth Support
- Installing the Paper Roll
- Installing the SIM Card
- Installing and Replacing SD Card
- Using the Battery
- Battery Behavior (No Power Pack)
- Connecting the Terminal Power Pack
- Charging the Battery
- VX 675 Base Stations
- Powering Up the Base
- Docking the Terminal on the Base
- Undocking the Terminal from the Base
- Connecting to USB Host
- Conducting a Bluetooth Transaction
- Conducting Wireless Transactions
- Conducting Smart Card Transactions
- Using the Magnetic Card Reader
- ECR (Fiscal Module) Support
- Specifications
- Maintenance
- VeriFone Service and Support
- Troubleshooting Guidelines
- Contact VeriFone
TERMINAL SETUP
Charging the Battery
24 VX 675 INSTALLATION GUIDE
To Connect the
Terminal Power
Supply
1 Insert the micro-USB plug into the micro-USB port of the VX 675, as shown in
the figure below.
Figure 12 VX 675 Power Supply Connection
2 Plug the AC power pack into a wall outlet or powered surge protector.
Once it loads the application, the terminal starts the initial VeriFone copyright
screen and displays a unique copyright screen. If there is no available application
in the terminal,
DOWNLOAD NEEDED appears on screen after the initial VeriFone
copyright screen.
Charging the
Battery
After unpacking your VX 675 terminal, connect the power pack to the unit for 6
hours or until fully charged.
The battery has a safety circuit to protect the Li-ion cells from overcharging and
over-discharging. If the battery is over-discharged, the safety circuit shuts down
the battery. The battery must then be recharged to restore operation.
NOTE
To protect against possible damage caused by lightning strikes and electrical
surges, consider installing a power surge protector.
NOTE
The terminal charges the VX 675 battery when the terminal is on the base. For
more information, see Docking the Terminal on the Base.
NOTE
The VX 675 terminal automatically shuts off when the battery reaches the
critically low charge state. If this occurs, the battery must be recharged for a
minimum of 1/2 hour before it can power the terminal. It may take several
recharge attempts to reset the safety circuit when charging a battery that has
been discharged below this critical state.