User's Manual
Table Of Contents
- VX 675
- Contents
- Preface
- Terminal Overview
- Terminal Setup
- Selecting Terminal Location
- Unpacking the Shipping Carton
- Examining Terminal Features
- Examining Connection Ports
- Installing the Paper Roll
- Installing the SIM Card
- Using the Smart Battery
- Battery Behavior (No Power Cable)
- Connecting the Terminal Power Pack
- Charging the Smart Battery
- Using the Base Station
- Powering Up the Base Station
- Mounting the Terminal Onto the Base Station
- Conducting Wireless Transactions
- Conducting Smart Card Transactions
- Using the Magnetic Card Reader
- Specifications
- Maintenance
- VeriFone Service and Support
- Troubleshooting Guidelines
- Index
- Contact VeriFone
TERMINAL SETUP
Installing the SIM Card
20 VX 675 INSTALLATION GUIDE
V
E
R
I
F
O
N
E
C
O
N
F
I
D
E
N
T
IA
L
R
EV
I
S
I
O
N
A
Installing the
SIM Card
The VX 675 terminal for GPRS modems supports the installation of a GSM SIM
(Subscriber Identity Module). Use the following procedure to install a SIM card.
To install or replace
the card
1 Turn off the terminal.
2 Place the terminal upside down on a soft, clean surface to protect the lens
from scratches.
3 Unscrew and remove the back compartment cover.
4 Lift the battery pack.
Figure 9 Removing the Back Compartment Cover
5 Insert the SIM card into the cardholder.
Figure 10 Inserting the SIM Card
A
B
NOTE
There is only one SIM slot. Before inserting the SIM card, position it as shown in
in the illustration below, with the card’s gold contacts facing the compartment. The
cardholder connector base has a set of contacts and a notch to ensure the SIM/R-
UIM card is positioned correctly. The SIM card has a notch on one corner to
ensure that it fits into the connector base in only one way.
B
A
MIS
M
IS