User's Manual

TERMINAL SETUP
Charging the Smart Battery
VX 675 I
NSTALLATION GUIDE 23
V
E
R
I
F
O
N
E
C
O
N
F
I
D
E
N
T
IA
L
R
EV
I
S
I
O
N
A
The VX 675 unit comes with a universal input power pack capable of operating
from voltages of 100 V to 240 V AC.
To Connect the
Terminal Power
Supply
1 Insert the micro-USB plug into the micro-USB port of the VX 675, as shown in
the figure below.
Figure 11 VX 675 Power Supply Connection
2 Insert the AC power cable into the power pack.
3 Plug the AC power cable into a wall outlet or powered surge protector.
The light indicators on the VX 675 appear when the terminal receives power.
Once it loads the application, the terminal starts the initial VeriFone copyright
screen and displays a unique copyright screen. If there is no available application
in the terminal,
DOWNLOAD NEEDED appears on screen after the initial VeriFone
copyright screen.
Charging the
Smart Battery
After unpacking your VX 675 terminal, install the battery and connect the power
pack to the unit for 6 hours or until fully charged.
The smart battery has a safety circuit to protect the Li-ion cells from overcharging
and over-discharging. If the battery is over-discharged, the safety circuit shuts
down the battery. The battery must then be recharged to restore operation.
NOTE
To protect against possible damage caused by lightning strikes and electrical
surges, consider installing a power surge protector.
NOTE
The terminal charges the VX 675 smart battery when the terminal is in the base
station. For more information, see Mounting the Terminal Onto the Base Station.