User's Manual

SYSTEM MESSAGES
Information Messages
VX 675 R
EFERENCE GUIDE 161
VERIFONE VX675
QT65010M
03/09/2012 Verix
* * T A M P E R * *
COPYRIGHT 1997-2012
VERIFONE
ALL RIGHTS RESERVED
If an attempt to break into the terminal’s system has
been made, the message
**TAMPER** is
displayed in place of the certificate on the startup
screen. The terminal will remain in this state until the
condition has been remedied.
**VERIFYING FILES**
COMPARE SIGNATURE
FILENAME.P7S
FILENAME.OUT
*AUTHENTIC*
This message appears on screen when the file
authentication module successfully authenticates a
new signature file.
*AUTHENTIC* appears for five
seconds and the terminal beeps three times to draw
attention to the filename of the certificate that could not
be authenticated.
This message remains on screen until all new
signature files are checked. New digital certificates are
always checked first, followed by new signature files,
in an uninterrupted process.
**VERIFYING FILES**
CHECK CERTIFICATE
FILENAME.CRT
*AUTHENTIC*
This message appears on screen when the file
authentication module successfully authenticates a
new digital certificate.
*AUTHENTIC* is displayed for
five seconds and the terminal beeps three times to
draw attention to the filename of the certificate that
could not be authenticated.
This message remains on screen until all new
certificates are checked, one by one. In special cases
where system certificates are being installed,
SYSTEM
CERTIFICATE
is displayed instead of CHECK
CERTIFICATE
.
Table 18 Information Messages
Display Action