User's Manual
Table Of Contents
- VX 680
- Contents
- Preface
- Terminal Overview
- Terminal Setup
- Selecting Terminal Location
- Unpacking the Shipping Carton
- Examining Terminal Features
- Examining Connection Ports
- Establishing Telephone Line Connections
- VX 680 Bluetooth® Support
- Installing the Paper Roll
- Installing and Replacing MSAM Cards
- Installing the SIM or R-UIM Card (GPRS and CDMA Models)
- Installing and Replacing SD Card
- Using the Smart Battery
- Battery Behavior (No Power Cable)
- Installing the Smart Battery
- Removing the Smart Battery
- Connecting the Terminal Power Pack
- Charging the Smart Battery
- Using the Base Station
- Powering Up the Base Station
- Mounting the Terminal Onto the Base Station
- Attaching the USB Dongles to the Base Station
- Charging the Spare Battery on the Base Station
- Conducting Wireless Transactions
- Conducting Smart Card Transactions
- Conducting Bluetooth® Transactions
- Using the Magnetic Card Reader
- Using the Stylus
- Specifications
- Maintenance
- VeriFone Service and Support
- Troubleshooting Guidelines
- Index
- Contact VeriFone
TERMINAL SETUP
Installing the SIM or R-UIM Card (GPRS and CDMA Models)
VX 680 I
NSTALLATION GUIDE 33
8 Close the printer cover.
Figure 20 Closing the Printer Cover
Installing the
SIM or R-UIM
Card (GPRS and
CDMA Models)
The VX 680 terminal for GPRS modems supports the installation of a GSM SIM
(Subscriber Identity Module). While the VX 680 terminal for CDMA modems
supports the installation of a R-UIM (Removable User Identity Module). Use the
following procedure to install a SIM or R-UIM card.
To install or replace
the card
1 Turn off the terminal.
2 Place the terminal upside down on a soft, clean surface to protect the lens
from scratches.
3 Remove the battery.
4 Remove the battery to expose the SIM/R-UIM compartment, as shown in
Figure 21.
Figure 21 Removing the Smart Battery