User's Manual
Table Of Contents
- VX 680
- Contents
- Preface
- Terminal Overview
- Terminal Setup
- Selecting Terminal Location
- Unpacking the Shipping Carton
- Examining Terminal Features
- Examining Connection Ports
- Establishing Telephone Line Connections
- Installing the Paper Roll
- Installing and Replacing MSAM Cards
- Installing the SIM or R-UIM Card (GPRS, CDMA, and 3G Models)
- Installing and Replacing SD Card
- VX 680 Bluetooth Support
- VX 680 3G and GPS Support
- Using the Smart Battery
- Battery Behavior (No Power Cable)
- Installing the Smart Battery
- Removing the Smart Battery
- Connecting the Terminal Power Pack
- Charging the Smart Battery
- Using the Base Station
- Powering Up the Base Station
- Mounting the Terminal Onto the Base Station
- Attaching the USB Dongles to the Base Station
- Charging the Spare Battery on the Base Station
- Conducting Wireless Transactions
- Conducting Smart Card Transactions
- Conducting Bluetooth Transactions
- Using the Magnetic Card Reader
- Using the Stylus
- Specifications
- Maintenance
- VeriFone Service and Support
- Troubleshooting Guidelines
- Index
- Contact VeriFone
TERMINAL SETUP
Installing and Replacing MSAM Cards
24 VX 680 INSTALLATION GUIDE
To Install and Replace
MSAM
1 Power off the terminal.
2 Place the terminal upside down on a soft, clean surface to protect the display
from scratches.
3 Unlock the printer cover.
Figure 12 Unlocking the Printer Cover
4 Unscrew the latch to expose the MSAM compartment (see illustration below).
Figure 13 Exposing the MSAM Compartment
5 Remove any previously installed MSAM card by pushing the snap that keeps
the SAM in place.
6 Install an MSAM card by placing the card facing the gold contacts down and
carefully snap it on the tab until it is fully inserted.
NOTE
Before inserting the MSAM card, position it as shown in the illustration below, with
the card’s gold contacts facing the MSAM compartment. The cardholder connector
base has a set of contacts and a notch on one corner to ensure that the MSAM
card fits into the connector base and positioned correctly. The MSAM
compartment door will not close properly if the MSAM card is installed incorrectly.