User's Manual
Table Of Contents
- VX 680
- Contents
- Preface
- Terminal Overview
- Terminal Setup
- Selecting Terminal Location
- Unpacking the Shipping Carton
- Examining Terminal Features
- Examining Connection Ports
- Establishing Telephone Line Connections
- Installing the Paper Roll
- Installing and Replacing MSAM Cards
- Installing the SIM or R-UIM Card (GPRS, CDMA, and 3G Models)
- Installing and Replacing SD Card
- VX 680 Bluetooth Support
- VX 680 3G and GPS Support
- Using the Smart Battery
- Battery Behavior (No Power Cable)
- Installing the Smart Battery
- Removing the Smart Battery
- Connecting the Terminal Power Pack
- Charging the Smart Battery
- Using the Base Station
- Powering Up the Base Station
- Mounting the Terminal Onto the Base Station
- Attaching the USB Dongles to the Base Station
- Charging the Spare Battery on the Base Station
- Conducting Wireless Transactions
- Conducting Smart Card Transactions
- Conducting Bluetooth Transactions
- Using the Magnetic Card Reader
- Using the Stylus
- Specifications
- Maintenance
- VeriFone Service and Support
- Troubleshooting Guidelines
- Index
- Contact VeriFone
TERMINAL SETUP
Installing the SIM or R-UIM Card (GPRS, CDMA, and 3G Models)
26 VX 680 INSTALLATION GUIDE
Installing the
SIM or R-UIM
Card (GPRS,
CDMA, and 3G
Models)
The VX 680 terminal for GPRS modems supports the installation of a GSM SIM
(Subscriber Identity Module), the VX 680 terminal for CDMA modems supports
the installation of a R-UIM (Removable User Identity Module). Use the following
procedure to install a SIM or R-UIM card.
To install or replace
the card
1 Turn off the terminal.
2 Place the terminal upside down on a soft, clean surface to protect the lens
from scratches.
3 Remove the battery.
4 Remove the battery to expose the SIM/R-UIM compartment, as shown in the
figure below.
Figure 17 Removing the Smart Battery
5 Insert the SIM or the R-UIM card into the cardholder.
Before inserting the SIM/R-UIM card, position it as shown in Figure 18, with the
card’s gold contacts facing the compartment. The cardholder connector base has
a set of contacts and a notch to ensure the SIM/R-UIM card is positioned correctly.
The SIM/R-UIM card has a notch on one corner to ensure that it fits into the
connector base in only one way.
NOTE
There is only one SIM/R-UIM slot and one SD slot (VX 680 3G has dual SIM
support, see Figure 19). Make sure you insert the SIM/R-UIM card into the SIM
slot, as shown in Figure 18.