User's Manual
Table Of Contents
- VX 680
- Contents
- Preface
- Terminal Overview
- Terminal Setup
- Selecting Terminal Location
- Unpacking the Shipping Carton
- Examining Terminal Features
- Examining Connection Ports
- Establishing Telephone Line Connections
- Installing the Paper Roll
- Installing and Replacing MSAM Cards
- Installing the SIM or R-UIM Card (GPRS, CDMA, and 3G Models)
- Installing and Replacing SD Card
- VX 680 Bluetooth Support
- VX 680 3G and GPS Support
- Using the Smart Battery
- Battery Behavior (No Power Cable)
- Installing the Smart Battery
- Removing the Smart Battery
- Connecting the Terminal Power Pack
- Charging the Smart Battery
- Using the Base Station
- Powering Up the Base Station
- Mounting the Terminal Onto the Base Station
- Attaching the USB Dongles to the Base Station
- Charging the Spare Battery on the Base Station
- Conducting Wireless Transactions
- Conducting Smart Card Transactions
- Conducting Bluetooth Transactions
- Using the Magnetic Card Reader
- Using the Stylus
- Specifications
- Maintenance
- VeriFone Service and Support
- Troubleshooting Guidelines
- Index
- Contact VeriFone
TERMINAL SETUP
Installing and Replacing SD Card
VX 680 I
NSTALLATION GUIDE 27
Figure 18 Inserting the SIM or R-UIM Card
The VX 680 3G terminal has dual SIM support; both SIM slots are required to
have SIM cards (from different networks), the dual SIM support allows the
terminal to switch SIMs when it detects poor or no network state.
Figure 19 Inserting the SIM on VX 680 3G
6 Install the battery (see Figure 27).
Installing and
Replacing SD
Card
The VX 680 terminal supports the installation of an SD card on certain
configurations. Use the following procedures to replace or install an SD card.
To install or replace
the SD card
1 Turn off the terminal.
2 Place the terminal upside down on a soft, clean surface to protect the lens
from scratches.
3 Remove the battery (see Figure 17).
4 After removing the battery, the SD card compartment is exposed, as shown in
in the illustration below. The SD card holder is labeled SD.
6,0
6,0
6,0