User's Manual

TERMINAL SETUP
VX 680 Bluetooth Support
VX 680 I
NSTALLATION GUIDE 31
To Connect the Power
Pack
1 Insert the round barrel connector into the power port on the Bluetooth AP
Charging Base Station, as shown in the following illustration.
Figure 24 Power Connection to the Bluetooth
AP Charging Base Station
2 Insert the AC power cord into the power pack.
3 Plug the AC power cord into a wall outlet or powered surge protector.
4 Confirm that the Base Station is powered up as indicated by the solid green
LED.
Telephone Line
Connection to the
Bluetooth AP
Charging Base
Station
The VX 680 supports telephone line connections through a USB Modem Dongle
connected to the phone cable.
To connect a
telephone line to the
Bluetooth AP Base
1 Connect the small connector on the modem cable to the modem port on the
Bluetooth AP Charging Base Station, as shown in the illustration below.
WARNING
Do not plug the power pack into an outdoor outlet or operate the terminal
outdoors.
NOTE
To protect against possible damage caused by lightning strikes and electrical
surges, consider installing a power surge protector.