User's Manual
Table Of Contents
- VX 680
- Contents
- Preface
- Terminal Overview
- Terminal Setup
- Selecting Terminal Location
- Unpacking the Shipping Carton
- Examining Terminal Features
- Examining Connection Ports
- Establishing Telephone Line Connections
- VX 680 Bluetooth® Support
- Installing the Paper Roll
- Installing and Replacing MSAM Cards
- Installing the SIM or R-UIM Card (GPRS and CDMA Models)
- Installing and Replacing SD Card
- Using the Smart Battery
- Battery Behavior (No Power Cable)
- Installing the Smart Battery
- Removing the Smart Battery
- Connecting the Terminal Power Pack
- Charging the Smart Battery
- Using the Base Station
- Powering Up the Base Station
- Mounting the Terminal Onto the Base Station
- Attaching the USB Dongles to the Base Station
- Charging the Spare Battery on the Base Station
- Conducting Wireless Transactions
- Conducting Smart Card Transactions
- Conducting Bluetooth® Transactions
- Using the Magnetic Card Reader
- Using the Stylus
- Specifications
- Maintenance
- VeriFone Service and Support
- Troubleshooting Guidelines
- Index
- Contact VeriFone
TERMINAL SETUP
Installing the SIM or R-UIM Card (GPRS and CDMA Models)
34 VX 680 INSTALLATION GUIDE
5 Insert the SIM or the R-UIM card into the cardholder.
Figure 22 Inserting the SIM or R-UIM Card
6 Install the battery (see Figure 24).
NOTE
There is only one SIM/R-UIM slot and one SD slot. Make sure you insert the SIM/
R-UIM card into the SIM slot, as shown in Figure 22.
Before inserting the SIM/R-UIM card, position it as shown in Figure 22, with the
card’s gold contacts facing the compartment. The cardholder connector base has
a set of contacts and a notch to ensure the SIM/R-UIM card is positioned
correctly. The SIM/R-UIM card has a notch on one corner to ensure that it fits into
the connector base in only one way.
6,0
6,0