User's Manual
Table Of Contents
- VX 685/VX 690
- Contents
- Preface
- Terminal Overview
- Setup
- Selecting a Location
- Unpacking the Shipping Carton
- Examining Terminal Features
- Examining the Connection Port
- Installing/ Replacing Paper Roll
- Installing/ Replacing SIM Card
- Installing/ Replacing MSAM Cards
- Installing/ Replacing the Micro SD Card
- Connecting Optional Devices
- Battery Features
- Connecting the Terminal to Power Source
- Base Stations
- Powering Up the Base
- 3G, GPRS, and GPS Support
- VX 690 Wi-Fi/BT Support
- Using the Smart Card Reader
- Using the Magnetic Card Reader
- Performing a Contactless Smart Card Transaction
- Specifications
- Maintenance and Cleaning
- Service and Support
- Troubleshooting Guidelines
- Contact VeriFone
SETUP
Connecting the Terminal to Power Source
VX 685/VX 690 I
NSTALLATION GUIDE 23
V
E
R
I
F
O
N
E
C
O
N
F
I
D
E
N
T
IA
L
R
E
V
I
S
I
O
N
B
.
1
Connecting the
Terminal to
Power Source
The terminal is either powered by an external power pack or the single cell Li-ion
rechargeable battery, which can be charged in the terminal by the AC/DC power
pack through the micro-USB connector for VX 690 and pin connector for VX 685.
When you have finished installing the necessary cards and/or optional devices,
you are ready to connect the terminal to the power source.
When the terminal has power and an application is loaded, the application starts
after the initial VeriFone copyright screen. If no application is loaded,
DOWNLOAD
NEEDED
appears on the display after the initial VeriFone copyright screen.
To Connect the
VX 690 Terminal to
the Power Source
1 Insert the micro-USB connector to the micro-USB port found on the side of the
terminal.
2 Plug the AC power cord into a wall outlet or power surge protector.
Figure 10 Connecting VX 690 to Power Source
To Connect the
VX 685 Terminal to
the Power Source
1 Insert the pin connector into the pin slot located at the back of the terminal.
WARNING
Do not connect the terminal to the power supply until all peripherals are attached.
Using an incorrectly rated power supply can damage the unit or cause it not to
work properly. Use only a power pack with P/N PWR260-001-XX-A. See
Specifications for detailed power supply specifications.
Do not plug the power pack into an outdoor outlet or operate the terminal
outdoors. Also, disconnecting power during a transaction can cause unstored
data files to be lost.
NOTE
To protect against possible damage caused by lightning strikes and electrical
surges, VeriFone recommends installing a power surge protector.