User's Manual
Table Of Contents
- VX 685/VX 690
- Contents
- Preface
- Terminal Overview
- Setup
- Selecting a Location
- Unpacking the Shipping Carton
- Examining Terminal Features
- Examining the Connection Port
- Installing/ Replacing Paper Roll
- Installing/ Replacing SIM Card
- Installing/ Replacing MSAM Cards
- Installing/ Replacing the Micro SD Card
- Connecting Optional Devices
- Battery Features
- Connecting the Terminal to Power Source
- Base Stations
- Powering Up the Base
- 3G, GPRS, and GPS Support
- VX 690 Wi-Fi/BT Support
- Using the Smart Card Reader
- Using the Magnetic Card Reader
- Performing a Contactless Smart Card Transaction
- Specifications
- Maintenance and Cleaning
- Service and Support
- Troubleshooting Guidelines
- Contact VeriFone
SETUP
VX 690 Wi-Fi/BT Support
32 VX 685/VX 690 INSTALLATION GUIDE
V
E
R
I
F
O
N
E
C
O
N
F
I
D
E
N
T
IA
L
R
E
V
I
S
I
O
N
B
.
1
6 Once the terminal discovers the Bluetooth AP Charging Base Station, the
base station’s friendly name is then displayed.
Pairing the Terminal
with a Bluetooth AP
Base Station
Even after you have successfully searched for a Bluetooth AP Base Station
using
the terminal, you will not be able to conduct Bluetooth
transactions until you have
paired the terminal and the base station.
To pair the terminal with the base station:
1 Navigate to the BT Devices menu, select the base station’s friendly name,
then press the Enter key.
2 Select the base station’s name, then press the Enter key.
NOTE
If the devices are unable to find each other after two minutes, press the Bluetooth
switch found in front of the Bluetooth AP Base. After pressing the switch, the three
LEDs will blink indicating that the Bluetooth AP Base is discoverable.
WARNING
Pressing the Bluetooth switch while there is an existing Bluetooth connection
may result in loss of connection, loss of modem profile, and loss of all modem
settings/configuration.