Specifications

2. Features and Procedures
Moneris Vx810 Duet Operating Manual v1.1.01 17
Comm Link Type
Sets the primary communications type.
Dial - sets dial as the primary communications type
CommServer - sets Ethernet as the primary communications type (default)
Alternate Dial - Do Not Use
ECRi - Do Not Use
Backup Support
If the terminal is configured for Ethernet communications, this parameter can be used to switch the
terminal to dial communications if Ethernet communication is not available.
Note: The dial communications cable must be connected to the Duet base and a functioning telephone
line before the terminal can successfully use dial communications as a backup.
None - If Ethernet communication is not available, the terminal cannot process transactions (default)
Auto Backup - If Ethernet communication is not available, the terminal displays "IP Connection
Failed" then automatically attempts to use the dial line to communicate with the Moneris Host.
Prompt Backup - If Ethernet communication is not available, the terminal displays "Use Backup Com
Confirm". Select Yes to have the terminal attempt to use the dial line to communicate with the Moneris
Host OR select NO to cancel the transaction. The "IP Connection Failed" message appears then the
terminal display the transactions menu.
Switch Backup - Moneris does NOT recommend using this setting. If Ethernet communication is not
available, the terminal switches to dial communications and stays on dial communications until this
parameter is changed to None, Auto Backup or Prompt Backup.
Use Backup - The terminal always uses dial communications.
Settle Comm Type
Sets the primary communications type for settlement. This must match the Comm Link Type parameter
value.
Dial - sets dial as the primary communications type
CommServer - sets Ethernet as the primary communications type
Alternate Dial - Do Not Use
ECRi - Do Not Use
Card Imprt
Enables/disables the “Imprint Card Press OK Key” prompt. This prompt may appear during a Purchase or
Refund transaction.
Key in 0 to turn the feature off
Key in 1 to turn the feature on
Additional Merchant Parameters (Edit MIT Menu)
Use the Edit MIT menu to edit additional merchant-related parameters.
Transactions menu (DEBIT & CREDIT) > CONFIGURATION menu (press OK) > Setup menu >
Merchant IDs > Edit MIT menu
IMPORTANT: Only some of the menu's parameters are listed below. You can ignore all other
parameters.