Specifications

2. Features and Procedures
Moneris Vx810 Duet Operating Manual v1.1.01 19
Sec Sett URL
The URL is automatically loaded into this parameter during initialization. This is the same value as
Pri Auth URL.
Sec Sett Port
The port number is automatically loaded into this parameter during initialization. This is the same value
as Pri Auth Port.
Cashback Parameters (Cashback Menu)
Use the Cashback menu to configure parameters related to the Cashback feature.
Transactions menu (DEBIT & CREDIT) > CONFIGURATION menu (press OK) > Setup menu >
Cashback menu
Amt 1 ($10)
default = $10
Amt 2 ($20)
default = $20
Amt 3 ($30)
default = $30
Determine the dollar amounts displayed on the terminal when the customer selects the Cashback option
on Debit transactions. The value displayed in brackets (e.g., ($10)) is the parameter's current value.
Select the parameter, key in the new dollar value (must be a multiple of 10) then press OK.
Note: The Cashback feature must be enabled (Cashback Option
parameter set to On). Each Amt
parameter has an allowable range, which is displayed when editing. The range is calculated based on the
dollar amounts of the other Amt parameters.
Hint: If you are increasing the amounts, start at Amt 3 then set Amt 2 followed by Amt 1 to avoid
overlapping ranges.
Amt Limit ($40)
default = $40
The maximum dollar amount customers can request (key in) if they do not select a pre-set Cashback
amount. The value displayed in brackets ($40) is the parameter's current value.
Select the parameter, key in the new dollar value (must be a multiple of 10) then press OK.
Note: The Cashback feature must be enabled (Cashback Option
parameter set to On). The maximum
value for this parameter is $990.
Menu and Editing Parameters (Menu Config Menu)
The Menu Config menu allows you to determine the menu items that are displayed and which of these
require the manager password
for access.
Transactions menu (DEBIT & CREDIT) > CONFIGURATION menu (pres OK) > Menus/Keys >
Menu Config menu
IMPORTANT: Some parameters cannot be edited unless the terminal batch is empty. If the "Edit
Not Allwd Batch Not Empty" message appears, perform a Batch Close then try editing the
parameter again.