Specifications

4. Configuring Your Terminal
52 Moneris Vx810 Duet Operating Manual v1.1.01
f. Select Edit, key in the prefix number (e.g., 9) then press OK.
g. Select Exit then select OK to save changes.
h. Press CANC ANNUL then press the * (ASTERISK) to return to the applications menu.
4. Enter the initialization phone number:
a. On the applications menu, select DEBIT & CREDIT.
The message "Activating App..." is displayed then the transactions menu appears.
b. Press OK to access the CONFIGURATION menu.
c. Select Setup, key in the manager password and press OK.
d. Scroll down and select Comm then select Next until "Pri Init Phone" appears.
e. Select Edit, key in the initialization phone number as follows then press OK.
If your merchant number begins
with:
Key in:
00301 1-888-699-7299
00302 1-888-358-8602
00304 1-888-332-8433
f. Select Exit then select OK to save changes.
g. Press CANC ANNUL then press the * (ASTERISK).
4.2.2. Configuring Dynamic IP Communications
If your terminal will communicate with the Moneris Host over the Internet using Public IP with dynamic
IP addressing, you must set up these parameters.
Note: If the terminal is configured to use Ethernet communications and dial backup is available, the
terminal will attempt to use dial communications when Ethernet communication is not available.
Note: The terminal's MAC address can be found on the yellow sticker on the bottom of the Duet base.
1. Ensure the Ethernet cable
is connected to the base and the wall jack.
2. Set the Comm Link parameters:
a. On the applications menu, select DEBIT & CREDIT.
The message "Activating App..." is displayed then the transactions menu appears.
b. Press OK to display the CONFIGURATION menu.
c. Select Setup, key in the manager password and press OK.
d. Scroll down and select Host.
e. Scroll to the following parameters and edit them:
Comm Link Type
- set to "CommServer".
Settle Comm Type
- set to "CommServer".
If you wish to configure dial backup, set the Backup Support
parameter to "Auto Backup" or "Prompt
Backup" (see “Configuring Dial Backup Support for IP” below). If dial is set up as backup, the
terminal will attempt to use dial communications when Ethernet communication is not available.
f. Select Exit then select OK to save changes.
g. Press CANC ANNUL then press the * (ASTERISK) to return to the applications menu.