Specifications

4. Configuring Your Terminal
Moneris Vx810 Duet Operating Manual v1.1.01 53
3. Set the dynamic IP Settings parameters:
a. While the applications menu is displayed, press the 2 key.
b. Key in the manager password and press OK.
c. Press the Ethernet Config key (
) then select IP. "IP Settings" appears.
d. Select Edit then select DHCP.
e. Select Exit then select Yes to save changes.
CommServer restarts and the terminal reboots back to the applications menu.
4.2.3. Configuring Static IP Communications
If your terminal will communicate with the Moneris Host over the Internet using Public IP with static IP
addressing, you must set up these parameters.
Note: If the terminal is configured to use Ethernet communications and dial backup is available, when
Ethernet communication is not available the terminal will attempt to use dial communications.
Note: The terminal's MAC address can be found on the yellow sticker on the bottom of the Duet base.
1. Disconnect the Ethernet cable
from the base BEFORE completing these steps.
2. Set the Comm Link parameters:
a. On the applications menu, select DEBIT & CREDIT.
The message "Activating App..." is displayed then the transactions menu appears.
b. Press OK to display the CONFIGURATION menu.
c. Select Setup, key in the manager password and press OK.
d. Scroll down and select Host.
e. Scroll to the following parameters and edit them:
Comm Link Type
- set to "CommServer".
Settle Comm Type
- set to "CommServer".
If you wish to configure dial backup, set the Backup Support
parameter to "Auto Backup" or "Prompt
Backup" (see “Configuring Dial Backup Support for IP” below). If dial is set up as backup, the
terminal will attempt to use dial communications when Ethernet communication is not available.
f. Select Exit then select OK to save changes.
g. Press CANC ANNUL then press the * (ASTERISK) to return to the applications menu.
3. Set the static IP Settings parameters.
a. At the applications menu, press the 2 key.
b. Key in the manager password and press OK.
c. Press the Ethernet Config key (
) then select IP. "IP Settings" appears.
d. Select Edit then select Static.
e. If your Ethernet network requires the parameters listed below, perform steps f and g for each
parameter. Otherwise skip to step h.
f. Select Next to view these parameters.
g. Select Edit to key in the address for each of these parameters. To key in a period (.), press the
number 1 key then the ALPHA key twice. Contact your Internet Service Provider (ISP) to determine
the addresses.