Specifications

4. Configuring Your Terminal
Moneris Vx810 Duet Operating Manual v1.1.01 55
5. Select Edit, key in the Terminal ID (the eight-digit number starting with 28 found on the back of the
terminal, e.g. 28123456) and press OK.
6. Select Next until “Merch Num” appears.
7. Select Edit, key in your 13-digit Moneris Merchant ID (e.g. 0030212345678) and press OK.
Note: Your Moneris Merchant ID was provided to you when Moneris contacted you to confirm your
terminal order. If you currently have a 9-digit merchant number beginning with a 1, 2 or 4, simply add
0030 to the beginning (i.e., 123456789 becomes 0030123456789).
8. Select Exit then select OK to save changes.
9. Press CANC ANNUL then press the * (ASTERISK) key to return to the applications menu.
4.4. Configuring the External PINPad
If you have set up an external PINPad for use with your terminal, follow the instructions below to
configure it on your terminal.
IMPORTANT: You must configure the external PINPad on your terminal BEFORE you initialize
your terminal for the first time.
To configure the external PINPad:
1. On the applications menu, select DEBIT & CREDIT.
"Activating App" appears followed by the transactions menu.
2. Press OK to access the CONFIGURATION menu.
3. Select Setup, key in the manager password and press OK.
4. Select Terminal. “Pin Baud” appears on the Edit Terminal menu.
5. Select Edit, key in 5 and press OK.
6. Select Next until “Pin Format” appears.
7. Select Edit, key in 4 and press OK.
8. Select Next until “PINpad Type” appears.
9. Select Edit then select Next until “SC5000EMV” appears.
10. Select Slct. The “Initialize PINpad” message appears.
11. Select Exit and press OK.
12. Press CANC ANNUL then press the * (ASTERISK) key to return to the applications menu.
4.5. Configuring the Modular Contactless Reader
If you have set up an optional modular contactless reader for use with your terminal, follow the
instructions below to configure it on your terminal.
To configure the contactless reader:
1. On the applications menu, select DEBIT & CREDIT.
"Activating App" appears followed by the transactions menu.
2. Press OK to access the CONFIGURATION menu.
3. Select Setup, key in your manager password and press OK.
4. Select Next until “Enable CTLS” appears.
5. Make sure “Enable CTLS” is set to On. If yes, skip to step 7. If no, proceed with step 6.