Specifications

PERFORMING DOWNLOADS
Back-to-Back Application Downloads
128 V
X
810 REFERENCE GUIDE
Back-to-back downloads require that one device, the sending device, be loaded
with the required applications. The receiving device is the receiving device. The
procedure assumes the following:
• The receiving device has no applications loaded.
• There is enough memory in the receiving device to complete the download.
• You are performing a full download
NOTE
The receiving device does not display an error message if there is not enough
memory to complete the download. However, the sending device displays
DOWNLOAD INCOMPLETE before returning to SYS MODE MENU 2.
Table 20 Back-to-Back Application Download Procedure
Step Display Action
1 Connect a MOD10 cable (P/N 05651-XX) between the RS-232 serial ports of
the devices using a UART Dongle connected to each device. Then start up
both devices.
2 (Application Prompt)
or
DOWNLOAD NEEDED
¹GO FILE NOT FOUND
After start up, the sending device displays the
application prompt; while the receiving device
displays
DOWNLOAD NEEDED.
For both devices, enter system mode by
simultaneously pressing F2 and F4.
3
SYSTEM MODE ENTRY
PASSWORD
_ _ _ _ _ _ _ _ _ _
For both devices, enter the default system
password “Z66831
.” This password is entered
as:
1 ALPHA ALPHA 6 6 8 3 1, then press ENTER.
4
SYS MODE MENU 1
EDIT PARAMETERS F2
DOWNLOAD F3
RESTART F4
©ª
For the receiving device, select DOWNLOAD
(F3)
. Enter the system mode password when
prompted.
SYS MODE DOWNLOAD Gnn
SINGLE-APP F3
MULTI-APP F4
Select SINGLE-APP (F3).
SYS MODE DOWNLOAD Gnn
FULL F3
PARTIAL F4
Select FULL (F3).