Specifications

SYSTEM MESSAGES
Information Messages
144 V
X
810 REFERENCE GUIDE
Information
Messages
The following information messages may appear when the V
x
810 device is in
system mode.
The operating system is unable to start the application specified in the *GO
variable for the following reasons:
• Application is not resident in the device.
• The *GO variable is not set in the Group 1 CONFIG.SYS file.
• The application file specified in the *GO variable does not exist in Group 1.
(The *GO variable cannot specify an application file stored in a file group other
than Group 1.)
• The application or a shared library used by the application either does not
exist or is not authenticated. All executables must be authenticated to run on
the device.
• There is not enough memory available to run the application requested in the
*GO variable.
This message displays when the
DEBUGGER F5 option in SYS MODE MENU 2 is
selected. The DBMON.OUT debugging monitor program is included in the SDK,
but is not stored in the device’s memory. To use the debugging tool, you must
sign, download, and authenticate the DBMON.OUT application.
This message displays if you select
REMOTE DIAGS F3 in SYS MODE MENU 2 and the
(optional) Terminal Management Agent (TMA) software is not resident in the
V
x
810 device. The TMA software is required to perform remote diagnostics. For
more information about support for remote diagnostics, contact your VeriFone
service provider.
In back-to-back downloads, the Target (receiving) device displays this message
on data transfer initiation when pressing the asterisk key (
*). To stop the upload,
press
CANCEL on either device (sending or Target).
This message is displayed when you select
FLASH FILES F3 in SYS MODE MENU 1
and select
CLEAR GROUP_NN F2 or CLEAR ALL FILES F3 to clear files from the flash
ROM memory of a specific file group (Group 1–15) or from the entire flash ROM
memory. This message remains until the files within the file group or all files in
flash ROM are deleted.
If you select
CLEAR ALL FILES F3, only application files stored in the flash-based file
system – not the files stored in SRAM – are erased.
DOWNLOAD NEEDED
LOAD DBMON.OUT
LOAD TERMINAL
MANAGEMENT AGENT
RECEIVING NOW
SYS MODE CLEAR
CLEARING FLASH
PLEASE WAIT