Specifications

SYSTEM MESSAGES
Information Messages
146 V
X
810 REFERENCE GUIDE
This message is displayed when you initiate a local diagnostic test of the device
keyboard through
KEYBOARD DIAG F1 in SYS MODE MENU 3. When invoked, the
decimal ASCII keycode of each key pressed appears to the right of
KEYCODE. For
example, pressing the
1 key on the device keypad displays the corresponding
ASCII code, 31.
This message is displayed when you initiate the procedure for modifying existing
system mode passwords through
PASSWORDS F2 in SYS MODE MENU 2. The menu
options displayed allow you to change the password of a file group (
F2) or the
system mode password (
F3).
This message is displayed when you select
PASSWORDS F2 in SYS MODE MENU 2to
modify the existing system mode password.
• NEW: Make the appropriate menu selections to enter the new password.
• AGAIN: Repeat the entry to confirm the new password.
• PASSWORD CHANGED: Displayed when the new password is accepted.
In a back-to-back download, the sending device displays this message when you
initiate an upload from the receiving device. To stop the upload, press
CANCEL on
either device.
When you invoke a local system mode diagnostic test of the magnetic stripe card
reader, status information appears for the data tracks (TRK1, TRK2, and TRK3)
on the card.
To perform this test, select
MAG CARD DIAG F2 in SYS MODE MENU 3 and swipe a
magnetic stripe card through the card reader.
NO DATA or VALID DATA: A successful test of the magnetic stripe card reader results
in one of these two messages for each track. Actual data stored on the card is not
displayed.
An error condition generates one of the following error messages for each track
with an error:
• NO DATA
• NO START
• NO END
• LRC ERR
• PARITY ERR
• REVERSE END
Press CANCEL to end the local diagnostic test of the card reader.
SYS MODE KBD TEST
KEYCODE NN
SYS MODE PASSWORD
FILE GROUP NN
SYS MODE ENTRY
SYS MODE PASSWORD
NEW
AGAIN
PASSWORD CHANGED
SYS MODE UPLOAD
UPLOADING NOW
TRK1:
TRK2:
TRK3: