Specifications

SETUP
Options
26 V
X
810 REFERENCE GUIDE
Options
VeriFone ships variants of the V
x
810 for different markets. Your device may have
a different configuration. Additionally, these variants can be ordered with different
options.
V
x
810 CTLS Module
This SD card slot on the V
x
810 also serves as an SDIO expansion port for
installing an optional V
x
810 CTLS module used for contactless smart card
transactions.
The V
x
810 CTLS module is composed of an RFID canopy with an RFID SD Card
attached via flex cable.
Figure 7 V
x
810 PIN pad with V
x
810 CTLS Module
To install the V
x
810 CTLS module:
1 Place the device facedown on a soft, clean surface to protect the lens from
scratches.
2 Remove the Dummy SD card from the SD card slot of the V
x
810.
3 Carefully insert the RFID SD card of the RFID canopy into the SD card slot of
the V
x
810.
Figure 8 Sliding the RFID Canopy
NOTE
Store the Dummy SD card in a safe place. This may be used again in the event
you want to remove the V
x
810 CTLS module.
NOTE
Use your fingers to push the RFID SD card into the SD card slot until the card
clicks into place. Take care not to let the SD card slip backwards once fully
inserted. SD card slot mechanisms do not prevent SD cards from being pulled
out even thought the SD card clicks into place.