User Manual

4
SAVE THESE INSTRUCTIONS
• For indoor use only.
• Always unplug the lamp and allow sufficient time for the bulb to cool before
performing bulb replacement or installation.
• Do not use this lamp with light dimmers, timers, motion detectors, voltage
transformers or extension cords.
• This product may cause interference with radios, cordless telephones
or devices that use a wireless remote control, such as televisions. If
interference occurs, move the product away from the device, plug the
product or device into a different outlet or move the lamp out of the line of
sight of the remote control receiver.
• Do not use this lamp if it has been damaged in any way; for example, the
power supply cord or plug has been damaged, liquid has been spilled or
objects have fallen onto the lamp, the lamp has been exposed to rain or
moisture, the lamp does not operate normally or has been dropped.
• Unplug this lamp during lightning storms or when not used for extended
periods of time.
• Avoid placing this lamp in areas that are dusty, humid/moist, lack ventilation
or are subject to constant vibration.
• Avoid placing this lamp in areas exposed to direct sunlight or close to heat-
radiating products such as heaters.
• Use only the type of bulb and maximum wattage indicated by Verilux.
• Protect the power cord from being walked on or pinched, particularly at the
plugs, convenience receptacles and the point where the power cord exits
the lamp.
• Lift the lamp by the shaft, not by the gooseneck.
• Do not clean this lamp with ammonia-based products or with abrasive
solvents or cleaners.
• After cleaning the lamp, properly wipe away and dry all moisture before
restoring power.
• Do NOT use a lubricating agent in assembly. See the troubleshooting
section of this manual if you are having difficulty assembling your lamp.
• To avoid damaging the lamp, do not position the head in a way that
compromises the stability of the lamp or renders it unable to stay upright.
Important Safeguards — continued
CAUTION:
VF02_MAN_Rev21.indd 4 8/19/15 1:43 PM