User Manual

7
Assembly Instructions
2. Hold the upper shaft with one hand
and release the ergonomic height
adjustment lever by gently pulling it
upward as shown in Fig. 2. Extend
the upper shaft approximately
30cm/12”. Lock the adjustment
lever by gently pushing it downward.
Once assembly is complete, raise or
lower the upper shaft to the desired
height by releasing and locking the
height adjustment lever.
Fig. 2
1. Attach the lamp head/gooseneck to the
shaft until the screw holes line up as
shown in Fig. 1. Use care when tucking
the wire into the shaft. Insert the screw
using the tightening tool. Turn clockwise
to tighten.
Close-up of screw hole in
the lamp head
Fig. 1
VF02_MAN_Rev21.indd 7 8/19/15 1:43 PM