User Manual

8
Assembly Instructions — continued
4. Remove the light diffuser from
the protective plastic bag.
Insert the plastic pegs at the
bottom of the light diffuser into
the openings near the bulb
socket. Snap the tab
into place as shown
in Fig. 4.
Note: Remove all
styrofoam packing
from the bulb area prior to
installing the light diffuser.
Fig. 4
3. Set the lamp base on the floor and insert the
lamp shaft over the base support unit until
the screw holes line up as shown in Fig. 3.
Insert the screw using the tightening tool.
Turn clockwise to tighten.
Close-up of screw hole in
the lamp base
Fig. 3
VF02_MAN_Rev21.indd 8 8/19/15 1:43 PM