User manual

2: Setting Up the Edge Devices
20 Verint Video Solutions
2. Change the desired settings.
3. Click OK.
Network\VSIP
The Network\VSIP pane contains the parameters related to the
VSIP (video services over IP) protocol. The values of these
parameters must be the same in the device and in
SConfigurator. For more information about the available
discovery methods, see page 5.
 VSIP Port—The VSIP port used by the device to
communicate with SConfigurator. The default value of all
Nextiva devices is 5510.
Note: VSIP ports 9541, 65500, and those under 1024 are
reserved and should not be used, not even for serial
port, video, or audio communication.
 Discovery Address—The IP address used by the device to
make its presence known to SConfigurator with the
broadcast method. The broadcast address is
255.255.255.255.
 Multicast Discovery Address—The IP address used by the
device to make its presence known to SConfigurator with
the multicast method. The current multicast address is
224.16.32.1 and should not be changed.
To change the VSIP settings:
1. In the parameter tree, expand the Network structure,
then click VSIP.
2. Change the desired settings.
3. Click OK.