User manual

SConfigurator User Manual
Verint Video Solutions 21
Network\SSL
On devices with an SSL digital certificate, you can enable
security so that they will only accept secure VSIP connections.
Once a device is in secure mode, you cannot access it anymore
with Telnet, you cannot perform firmware updates through the
IP network on it, and its access through the web interface (for
the S1600e, S1700e, and S2500e devices).
To enable SSL security on the device, the parameters are:
 Enable Security—The indication of whether the device only
accepts SSL VSIP connections.
 Change SSL Passkey—To change the password shared by
SConfigurator and all SSL-enabled devices to establish a
secure system. You can change it only if the connection
between the device and SConfigurator is secure.
For more information about SSL, see the “Enabling Security”
chapter on page 53.
To change the SSL settings:
1. In the parameter tree, expand the Network structure,
then click SSL.
2. To change the SSL passkey:
a. Click Change SSL Passkey.
The SSL Passkey window appears.
b. Type the passkey, then click OK.
3. To restrict the device to secure connections only, check
Enable Security.
After its reboot, the device will accept only SSL VSIP
connections.