Indoor Air Quality Meter 1008 Rev. 2.x Meters The Value Leader www.tpi-thevalueleader.
Contents 1. Introduction 1. Introduction 2. General Overview 3. 3.1 3.2 3.3 Familiarization Front View Soft Keys Back View 4. 4.1 4.2 4.3 4.4 4.5 Operation Turning On & Off / Performing a Test / Main Display Selecting Temperature Units Min / Max Mode Activating the Backlight Setting CO2 Alarm Level 5. Data Logging 6. Retrieving Logged Data The following guidelines will help prevent damage to your sensors: 7. Technical Specifications 8. 8.1 8.2 Maintenance Battery Replacement Service 9.
General Overview (Continued) This manual will guide you through the functions of the TPI 1008 which will give you many years of reliable service.
3.2 Soft Keys 3.3 Back View On / Off key - Used to turn the IAQ meter on or off. Press to turn on, press and hold to turn off. Up Arrow key - Used to select and change parameters. Down Arrow key - Used to select and change parameters. Mode key - Used to switch between Celsius and Fahrenheit units of display and to enter CO2 alarm level input mode. Press to switch between Celsius and Fahrenheit units. Press and hold to enter and exit CO2 alarm level mode.
4. Operation 4.2 Selecting Temperature Units Pressing the 4.1 Turning On & Off / Performing a Test / Main Display Press the key switches the temperature display between °F and °C. 4.3 Min / Max Mode key and the 1008 will begin a 30 second countdown. During this time the 1008 performs a self diagnostic. Once the countdown ends the 1008 will display CO2 and Temperature. Enter the area to be tested, the measured values will be displayed.
4.5 Setting CO2 Alarm Level 5. Data Logging The 1008 is equipped with an audible and visual alarm for carbon dioxide. The alarm level is factory set to off. When CO2 above the alarm level is measured, the 1008 will beep and the display will flash red. To activate data logging press the key until the logging time setup screen is displayed. Once the logging function is activated all previously logged data is written over.
6. Retrieving Logged Data 7. Technical Specifications Logged data can be displayed on the 1008 display or sent to a PC by using the USB cable and software included. The PC software also provides the capability of real time monitoring from a PC.
. Maintenance It is recommended that the instrument be calibrated every 12 months. Please consult Test Products International for further details (800) 368-5719. 9. Technical Information Recommended Levels by Agency Parameter 8.1 Battery Replacement When the batteries become low they will require replacement. 1. Turn the meter over so the back is facing you. 2. Loosen the screw holding down the battery cover located under the tilt stand. 3. Lift the tilt stand up and remove the battery cover. 4.
10. Error Codes & Troubleshooting CO2 Sensor Error If the CO2 sensor fails to initialize or is faulty the 1008 will display an error code. Try turning the 1008 off and on again. If it displays the error code again the 1008 is in need of service. Please return your instrument to TPI. See section 9.2 for instructions on returning your meter. Temperature Sensor Error If the temperature sensor fails to initialize or is faulty the 1008 will display an error code. Try turning the 1008 off and on again.
Notes: Notes:
Test Products International, Inc. 9615 SW Allen Blvd., Ste. 104 Beaverton, OR 97005 Tel: 503-520-9197 Fax: 503-520-1225 www.tpi-thevalueleader.com Test Products International, Ltd.
