Install Instruction Manual

VERIS INDUSTRIES
™
inStallation GUiDe
tWS SerieS
Z204455-0D PAGE 3 ©2010 Veris Industries USA 800.354.8556 or +1.503.598.4564 / [e-mail] 06101
Alta Labs, Enercept, Enspector, Hawkeye, Trustat, Veris, and the Veris ‘V’ logo are trademarks or registered trademarks of Veris Industries, L.L.C. in the USA and/or other countries.
menu tws calibration instructions
Temperature calibration allows for calibration offset of ±9.9°F (±5°C) at user
discretion. Temperature can be field calibrated by moving the RUN/CAL jumper to CAL
position.
O U T P U T
0 - 1 0 V
T E M P S E T
+ 5 0 + 9 5
C A L T
+ 0 . 0 F
6 8 . 5 º F
U N I T S
* º F º C
S E T P O I N T
7 0 F
S E T P O I N T
7 0 F
SETPOINT MODE
(Enter by any keypress when RUN/CAL
jumper is in RUN position)
NORMAL MODE
press± to change; press* to select
(setpoint in ˚C if Celsius units are selected)
press± to change; press* to select
(setpoint in ˚C if Celsius units are selected)
press± to change; press* to select
(cal in ˚C if Celsius units are selected)
press± to change; press* to select
press± to change; press* to select
press± to change; press* to select
(choices are 50-95˚F/10-35˚C or 32-122˚F/0-50˚C)
CONFIG/CAL MODE
(Enter by any keypress when RUN/CAL
jumper is in CAL position)
Output scaling
(does not affect LCD display)
Only for switch in
Volts position