Install Instructions

Installation Guide
Pressure Monitoring
Installation Guide
Pressure Monitoring
Installation Guide
Pressure Monitoring
Installation Guide
Pressure Monitoring
Z207504-0N Page 5 of 8
©2021
Veris Industries 12345 SW Leveton Drive, Tualatin, OR 97062 USA / 800.354.8556 or +1.503.598.4564 / [e-mail] 0721
Alta Labs, Enercept, Enspector, Hawkeye, Trustat, Aerospond, Veris, and the Veris ‘V’ logo are trademarks or registered trademarks of Veris Industries, L.L.C.
in the USA and/or other countries. Other companies’ trademarks are hereby acknowledged to belong to their respective owners.
The Bluetooth word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks is under license.
Z207504-0N Page 6 of 8
©2021
Veris Industries 12345 SW Leveton Drive, Tualatin, OR 97062 USA / 800.354.8556 or +1.503.598.4564 / [e-mail] 0721
Alta Labs, Enercept, Enspector, Hawkeye, Trustat, Aerospond, Veris, and the Veris ‘V’ logo are trademarks or registered trademarks of Veris Industries, L.L.C.
in the USA and/or other countries. Other companies’ trademarks are hereby acknowledged to belong to their respective owners.
The Bluetooth word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks is under license.
Z207504-0N Page 8 of 8
©2021
Veris Industries 12345 SW Leveton Drive, Tualatin, OR 97062 USA / 800.354.8556 or +1.503.598.4564 / [e-mail] 0721
Alta Labs, Enercept, Enspector, Hawkeye, Trustat, Aerospond, Veris, and the Veris ‘V’ logo are trademarks or registered trademarks of Veris Industries, L.L.C.
in the USA and/or other countries. Other companies’ trademarks are hereby acknowledged to belong to their respective owners.
The Bluetooth word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks is under license.
Z207504-0N Page 7 of 8
©2021
Veris Industries 12345 SW Leveton Drive, Tualatin, OR 97062 USA / 800.354.8556 or +1.503.598.4564 / [e-mail] 0721
Alta Labs, Enercept, Enspector, Hawkeye, Trustat, Aerospond, Veris, and the Veris ‘V’ logo are trademarks or registered trademarks of Veris Industries, L.L.C.
in the USA and/or other countries. Other companies’ trademarks are hereby acknowledged to belong to their respective owners.
The Bluetooth word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks is under license.
Installation, Wiring
& Conguration
(cont.)
Installation, Wiring
& Conguration
(cont.)
Installation, Wiring
& Conguration
(cont.)
Installation, Wiring
& Conguration
(cont.)
DIP Switch 1: Scale
ON = Pascal (m/s)
OFF = in. WC (ft/min)
DIP Switch 2: Mode
ON = Velocity
OFF = Pressure
DIP Switch 3: Direction**
ON = Unidirectional
OFF = Bidirectional
DIP Switch 4: Response
ON = Slow
OFF = Fast
*DIP switches are all set to OFF by the factory.
**Velocity mode is unidirectional regardless of DIP switch setting.
DIP Switch 5: Output
ON = 4-20 mA
OFF = Voltage
DIP Switch 6: Volt Scale
ON = 0-5 Vdc
OFF = 0-10 Vdc
DIP Switch 7: Bluetooth
ON = Disabled
OFF = Enabled
DIP Switch 8: Unused
DIP Switch Settings
Scale Mode Direction Response Output Volt Scale
ON
Pascal/MPS VelocityUni Slow mA 5V
OFF
in. WC/FPM PressureBiFast Volt 10V
123456
Unused
Unused
Unused
8
Bluetooth
Disabled
Enabled
7
7. Set rotary switch to the desired setting. Align the arrow (not the slot) on the
rotary switch to the desired full-scale range. LCD models momentarily indicate
the selected range.
6. Set DIP switches to desired settings.*
2-wire, 4-20 mA Current Loop Output
3-wire, 0-5 V/0-10 V Voltage Output
DIGITAL CONTROL
Digital
Output
Return
V+
1.000
0
1
2
3
4
5
6
7
PWR
mA RTN
{
RMT.
ZERO
ZERO
1.000
0
1
2
3
4
5
6
7
{
RMT. ZERO
ZERO
DIGITAL CONTROL
Digital
Output
V IN
-
POWER SOURCE
24 Vac/dc
-
+
V+/PWR
V-/GND
VOUT
Operation
9. Wait ve seconds, then press and hold the ZERO pushbutton for two
seconds or provide contact closure on the AUX ZERO terminal. This will reset
the output and display to zero pressure. For best accuracy, press the ZERO
button while both ports are open to atmospheric pressure. To protect the unit
from accidental zero, this feature is enabled only when the detected pressure
is within about 0.5 in. WC (125 Pa) of factory calibration.
10. Connect desired external tubing to the PX3.
PX3 Series devices employ high performance sensors and sophisticated temperature
compensation circuitry. The sensor achieves its best accuracy after an initial warm-up
period. During the rst few minutes of operation, readings at zero pressure and the
lowest pressure ranges appear erroneous. Following this initial warm-up period, the PX3
device maintains its specied accuracy and stability.
The LCD momentarily indicates range ‘SET’ when a selection is made. Pressure is normally
indicated on the display. Units are in inches water column (in. WC), Pascals (Pa) or
kilopascals (kPa) as indicated on the display. The display shows ‘OVER’ when the pressure
is over range.
8. Connect the transmitter to the control system and power supply as indicated
below. Optional: Connect the ZERO terminals to the digital output (contact
closure) of the control system.
Environment-Friendly Use Period (EFUP) Table
China RoHS Compliance
Information
本表格依据SJ/T11364的规定编制。
O: 表示该有害物质在该部件所有均质材料中的含量均在GB/T 26572规定的限量要求以下。
X: 表示该有害物质至少在该部件的某一均质材料中的含量超出 GB/T 26572规定的限量要求。
（企业可在此处，根据实际情况对上表中打 的技术原因进行进一步说明。）
This table is made according to SJ/T 11364.
O: indicates that the concentraon of hazardous substance in all of the homogeneous materials
for this part is below the limit as spulated in GB/T 26572.
X: indicates that concentraon of hazardous substance in at least one of the homogeneous
X O O O O O
materials used for this part is above the limit as spulated in GB/T 26572
Z000057-0B
部件名称
Part Name
有害物质 - Hazardous Substances
铅 (Pb)
汞 (Hg)
镉 (Cd) 六价铬 (Cr (VI)) 多溴联苯 (PBB) 多溴二苯醚 (PBDE)
电子件
Electronic
Rotary Switch Settings
Range 01 Model, Field Selectable (WC / ft/min or Pa / m/s)
(P) Pressure Mode (V) Velocity Mode
0 0 to 0.1 in. WC 0 0 to 500 ft/min
1 0 to 0.25 in. WC 1 0 to 1,000 ft/min
2 0 to 0.5 in. WC 2 0 to 2,000 ft/min
3 0 to 1 in. WC 3 0 to 3,000 ft/min
4 0 to 0.1 in. WC 4 0 to 500 ft/min
5 0 to 0.25 in. WC 5 0 to 1,000 ft/min
6 0 to 0.5 in. WC 6 0 to 2,000 ft/min
7 0 to 1 in. WC 7 0 to 3,000 ft/min
(P) Pressure Mode (V) Velocity Mode
0 0 to 25 Pa 0 0 to 2.5 m/s
1 0 to 50 Pa 1 0 to 5 m/s
2 0 to 100 Pa 2 0 to 10 m/s
3 0 to 250 Pa 3 0 to 15 m/s
4 0 to 25 Pa 4 0 to 2.5 m/s
5 0 to 50 Pa 5 0 to 5 m/s
6 0 to 100 Pa 6 0 to 10 m/s
7 0 to 250 Pa 7 0 to 15 m/s
Range 02 Model, Field Selectable (WC / ft/min or Pa / m/s)
(P) Pressure Mode (V) Velocity Mode
0 0 to 1 in. WC 0 0 to 3,000 ft/min
1 0 to 2.5 in. WC 1 0 to 4,000 ft/min
2 0 to 5 in. WC 2 0 to 5,000 ft/min
3 0 to 10 in. WC 3 0 to 6,000 ft/min
4 0 to 1 in. WC 4 0 to 3,000 ft/min
5 0 to 2.5 in. WC 5 0 to 4,000 ft/min
6 0 to 5 in. WC 6 0 to 5,000 ft/min
7 0 to 10 in. WC 7 0 to 6,000 ft/min
(P) Pressure Mode (V) Velocity Mode
0 0 to 250 Pa 0 0 to 15 m/s
1 0 to 500 Pa 1 0 to 20 m/s
2 0 to 1,000 Pa 2 0 to 25 m/s
3 0 to 2,500 Pa 3 0 to 30 m/s
4 0 to 250 Pa 4 0 to 15 m/s
5 0 to 500 Pa 5 0 to 20 m/s
6 0 to 1,000 Pa 6 0 to 25 m/s
7 0 to 2,500 Pa 7 0 to 30 m/s
Rotary Switch Settings (cont.)
Range 05 Model, Field Selectable (P) Pressure or (V) Velocity Mode,
Field Selectable (WC / ft/min or Pa / m/s)
(P) Pressure Mode (V) Velocity Mode
0 0 to 0.1 in. WC 0 0 to 500 ft/min
1 0 to 0.25 in. WC 1 0 to 1,000 ft/min
2 0 to 0.5 in. WC 2 0 to 2,000 ft/min
3 0 to 1 in. WC 3 0 to 3,000 ft/min
4 0 to 2.5 in. WC 4 0 to 4,000 ft/min
5 0 to 5 in. WC 5 0 to 5,000 ft/min
6 0 to 10 in. WC 6 0 to 6,000 ft/min
7 0 to 10 in. WC 7 0 to 7,000 ft/min
(P) Pressure Mode (V) Velocity Mode
0 0 to 25 Pa 0 0 to 2.5 m/s
1 0 to 50 Pa 1 0 to 5 m/s
2 0 to 100 Pa 2 0 to 10 m/s
3 0 to 250 Pa 3 0 to 15 m/s
4 0 to 500 Pa 4 0 to 20 m/s
5 0 to 1,000 Pa 5 0 to 25 m/s
6 0 to 2,500 Pa 6 0 to 30 m/s
7 0 to 2,500 Pa 7 0 to 35 m/s
1/2-inch NPT female threaded coupler
5. For applications using conduit, remove the cable gland nut on the bottom of the
unit. Thread a standard 1/2-inch NPT female threaded coupler onto the body of the cable
gland. Connect the opposite end of the coupler to the conduit.