Installation Guide

You need this number later when confirming that the device has connected to Reveal. You
can find the serial number on the label on the side of the device.
Step 2: Find a good location to mount the device.
The device should be mounted in a location with a clear view of the sky and where it does not
interfere with the safe operation of the asset, or where it is exposed to road debris or high-
pressure water spray that can damage the device.
Do not mount the device under the floor in an enclosed metal trailer or container as this can
limit connectivity and data.
Do not mount the device facing down, underneath the asset, because ground reflections can
impair the signal reception and reporting accuracy.
Possible locations include:
• Top of the trailer’s tongue
• Hitch rail
• Side rails
• Front bulkhead
Do not mount the device until you have activated and tested the device.
Step 3: Activate and test the device.
1. Hold the device in the mounting location.
2. Press the Status button.
3. Check the status LEDs.
I C O N
N A M E
S T A T U S
Battery
• 1 flash = 10-25% full
• 2 flashes = 25 - 50% full
• 3 flashes = 50 - 75% full
• 4 flashes = 75 - 100% full
Network
• Slow flash: device is seeking network.
• Solid: network connection acquired
• Fast flash: network connection failed.
GPS
• Slow flash: device is seeking GPS.
• Solid: GPS location acquired.