Installation Guide

After a successful Network and GPS test, and after completing the device setup and activation in the
Reveal Hardware Installer app.
1. Hold the device where it will be mounted mark the positions of the four mounting holes where you will
drill.
2. If using the screws, pre-drilling the holes is recommended.
3. Secure the device to the asset using the included screws or bolts. Do not over torque. Do not use
rivets or countersink screws. Over torqueing or using the wrong mounting hardware can cause the
plastic surrounding the mounting hole to crack.
____________________________________________________________________________________
FCC Notes
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation. Changes or modifications not
expressly approved by the party responsible for compliance could void the user’s authority to operate the
equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
• receiver is connected.
Consult the dealer or install technician for help.