Operation Manual

4. Mark the mounting holes,
then remove the wall mount
bracket from the wall.
5. Drill holes for the screw
anchors.
6. Insert the screw anchors
in the holes in the wall,
then insert the screws into
the screw anchors and tighten the screws. Leave screws
extended about 0.2 inches from the wall.
7. Verify the screws are positioned correctly by placing the wall
bracket on the screws. Remove the wall bracket from the
wall.
8. Place the Gateway on the wall bracket and slide the Gateway
forward until it locks in place.
9. To secure the Gateway,
attach the bracket
to the Gateway using
the single screw you
removed from the foot.
10. Slide the wall mount
bracket with the
attached Gateway on
the screws, then slide
the bracket down until
it locks in place.
GETTING TO KNOW
YOUR GATEWAY