User guide

Wi-Fi Settings

Verizon 4G LTE Router MBR1515LVW

Note: The authentication is separate from the data encryption. You can

select authentication that requires a shared key but still leaves data

transmissions unencrypted. Security is stronger if you use both the

Shared Key and WEP encryption settings.

5. Select the Encryption Strength setting:

• 64-bit.

Enter 10 hexadecimal digits (any combination of 0–9, a–f, or A–F).

• 128-b

it. Enter 26 hexadecimal digits (any combination of 0–9, a–f, or A–F).

6. Enter th

e encryption keys. You can manually or automatically program the four data

encryption keys. These values must be identical on all computers and access points in your

network:

• Passphras

e. To use a passphrase to generate the keys, enter a passphrase, and

click Generate. This procedure automatically creates the keys. Wireless stations

must use the passphrase or keys to access the router.

Note: Not all wireless adapters support passphrase key generation.

• Key 1–Key4. These values are not case-sensitive. You can manually enter the four

data encryption keys. These values must be identical on all computers and access

points in your network. Enter 10 hexadecimal digits (any combination of 0

–9, a–f, or

–F).

7. Select which of

the four keys is the default.

Data transmissions are alwa

ys encrypted using the default key. The other keys can be

used only to decrypt received data. The four entries are disabled when WPA-PSK or WPA

authentication is selected.

8. Click Apply to save

your settings.

Use Push 'N' Connect (WPS) to Configure Your Wireless

Network

To use Push 'N' Connect, your wireless computers or devices must support Wi-Fi Protected

Setup (WPS). Compatible equipment usually has the WPS symbol on it. WPS can

configure the network name (SSID) and set up WPA/WPA2 wireless security for the router

and the wireless computer or device at the same time.

WPS considerations:

• The Push 'N' Connect featu

re is based on the WPS standard. All other Wi-Fi-certified and

WPS-capable products should be compatible with products that implement Push 'N'

Connect.