User guide

37
Using the Belt Clip accessory
1. The backside of the Belt Clip holder has a round
locking peg. Slide it down between the side
channels of the Belt Clip until you hear it click
into place. After the holder is attached to the
Belt Clip, you can rotate it 360 degrees.
2. Align the Personal Wearable Device's three
alignment grooves (located at the bottom) with
the bottom curved clip of the holder and push
down firmly until you hear it click.
3. To separate and release the Personal Wearable
Device, gently press back the top tab of the
holder. Then lift the Personal Wearable Device up
and out to remove.
4. Press the Release but on to separate the belt clip
from the Belt Clip holder.