Instruction manual

Albatros II

2012-09

Page 13

1 2

2.3.5 Thorax support

To stabilize and support your thorax, the lift is

equipped with thorax pillow and velcro belts

to stabilize.

The thorax support can be adjusted in 2

different positions 1045 mm, 1200 mm.

These positions are measured from the

footplate until the top of the thorax support.

1. Remove the safety pin .

2. Adjust the thorax support in the

desired position. The position from

attachment plate  shall be like

shown in figure.

3. Mount the safety pin  securely.

2.3.6 Raising and lowering the cantilever arm

The manual control allow the cantilever arm to be adjusted

smoothly to any point.

= Raise the cantilever arm

= Lower the cantilever arm

When using the lift function until the end of the hoist

motor the limit switch is activated by electronics (security

function). Use the lifting function only in the middle of the

adjustment range.

Force required to activate the pushbutton: < 5N

Position the manual control to the top tube of the handles for moving the patient hoist. This is

the most ergonomic position.